SnSxSe2-x单晶纳米片的可控制备与表征

锡二硫族化合物可以通过改变硫和硒的含量来连续调控三元合金材料的带隙、载流子浓度等物理化学性质,在电子和光电子器件应用上具有巨大的潜力。本文采用化学气相沉积(CVD)技术可控地制备了不同元素组分的SnS_xSe_2-x(x=0,0.2,0.5,0.8,1.0,1.2,1.5,1.8,2.0)单晶纳米片。采用扫描电子显微镜(SEM)、原子力显微镜(AFM)、能量色散X射线光谱(EDS)、透射电子显微镜(TEM)以及拉曼光谱等手段对SnS_xSe_2-x纳米片进行了综合表征。结果表明本方法成功实现了元素百分比可调的SnS_xSe_2-x单晶纳米片的可控制备。重点研究了依赖于元素百分比的SnS_xSe_2-x的拉曼特征谱,实验结果与基于密度泛函理论(DFT)的第一性原理计算得到的SnS_xSe_2-x的拉曼仿真谱高度吻合,理论计算结果较好地诠释了实验拉曼光谱发生变化的原因。本研究提供了一种元素百分比可调的三元SnS_xSe_2-x单晶纳米片的可控制备方法,同时对锡二硫族化合物的明确、无损识别提供了方案。     

Development of a Chitosan/Nickel Phthalocyanine Composite Based Conductometric Micro-sensor for Methanol Detection

Thin-film composite of chitosan/nickel phthalocyanine (NiPc) was electrochemically deposited on the fingers of interdigitated gold electrodes, applying chronoamperometric polymerization technique. The presence of crystallized NiPc in the chitosan was confirmed by EDX and FTIR analysis. Acetone, ethanol, and methanol gas-sensing properties of the films prepared at optimum conditions were studied at atmospheric temperature, through differential measurements at an optimized frequency of 10 kHz, using a lock-in amplifier. The conductometric sensor presents the highest sensitivity of 60.2 μS.cm⁻¹(v/v) for methanol and 700 ppm as the limit of detection. For validation, the methanol content of a commercial rubbing alcohol was determined.     

以磷化铁为添加剂沿(111)面生长磷掺杂金刚石大单晶

掺杂是调控金刚石性能的一种重要手段。本文采用温度梯度法,在5.6 GPa、1 312 ℃的条件下,选用Fe₃P作为磷源进行磷掺杂金刚石大单晶的合成。金刚石样品的显微光学照片表明,随着Fe₃P添加比例的增加,金刚石晶体的颜色逐渐变深,包裹体数量逐渐增加,晶形由板状转变为塔状直至骸晶。金刚石晶形的变化表明Fe₃P的添加使生长金刚石的V形区向右偏移,这是Fe₃P改变触媒特性的缘故。红外光谱分析表明,Fe₃P的添加使金刚石晶体中氮含量上升,这说明磷的进入诱使氮原子更容易进入金刚石晶格中。激光拉曼光谱测试表明,随着Fe₃P添加比例的增加,所合成的掺磷金刚石的拉曼峰位变化不大,其半峰全宽(FWHM)值变大,这说明磷的进入使得金刚石晶格畸变增加。XPS测试结果显示,随着Fe₃P添加比例的增加,金刚石晶体中磷相对碳的原子百分含量也会增加,这意味着添加Fe₃P所合成的金刚石晶体中有磷存在。     

雾化辅助化学气相沉积法氧化镓薄膜生长研究

采用自主设计搭建的雾化辅助化学气相沉积系统设备,开展了Ga₂O₃薄膜制备及其特性研究工作。通过X射线衍射研究了沉积温度、系统沉积压差对Ga₂O₃薄膜结晶质量的影响。结果表明,Ga₂O₃在425~650 ℃温度区间存在物相转换关系。随着沉积温度从425 ℃升高至650 ℃,薄膜结晶分别由非晶态、纯α-Ga₂O₃结晶状态向α-Ga₂O₃、β-Ga₂O₃两相混合结晶状态改变。通过原子力显微镜表征探究了生长温度对Ga₂O₃薄膜表面形貌的影响,从475 ℃升高至650 ℃时,薄膜表面粗糙度由26.8 nm下降至24.8 nm。同时,高分辨X射线衍射仪测试表明475 ℃、5 Pa压差条件下的α-Ga₂O₃薄膜样品半峰全宽仅为190.8″,为高度结晶态的单晶α-Ga₂O₃薄膜材料。     

PSO-LSSVM对LIBS定量分析精度的提高

针对土壤定量分析受基体效应影响大，LIBS定量分析精度不佳等问题，采用粒子群算法对LSSVM进行优化，提高模型的精确度。选取Pb Ⅰ 405.78 nm和Cr Ⅰ 425.44 nm作为分析谱线进行分析。采集十二个不同浓度样品的特征光谱，每个浓度样品在不同点采集20组数据，将其中17组数据设为训练集，3组数据设为预测集，用LSSVM和PSO-LSSVM两种方法建立定标模型。对比两种模型的拟合相关系数（R2）、训练集均方根误差（RMSEC）和预测集均方根误差(RMSEP)。由于自吸收效应的影响，随着浓度的增加，预测值逐渐低于实际值，LSSVM定标模型的拟合程度较低，无法达到实验要求，模型性能有待提高。利用粒子群算法对LSSVM的模型参数惩罚系数和核函数参数进行优化，得到最佳的参数组合，Pb元素为(8 096.8, 138.865 7)，Cr元素为(4 908.6, 393.563 5)，用最佳的参数组合构建LSSVM的定标模型。相比于LSSVM，PSO-LSSVM定标模型的精确度更高，Pb和Cr元素的R2提高到了0.982 8和0.985 0，拟合效果明显提升。Pb和Cr元素的训练集均方根误差由0.026 0 Wt%和0.027 2 Wt%下降到0.022 4 Wt%和0.019 1 Wt%，预测集均方根误差由0.101 8 Wt%和0.078 8 Wt% 下降到0.045 8 Wt%和0.042 0 Wt%，模型的稳定性进一步提高。说明PSO-LSSVM算法能够更好地降低土壤基体效应和自吸收效应带来的影响，提高分析结果的精确度与稳定性。     

Deciphering the Structure and Chemical Composition of Drug Nanocarriers: From Bulk Approaches to Individual Nanoparticle Characterization

Drug nanocarriers (NCs) with sizes usually below 200 nm are gaining increasing interest in the treatment of severe diseases such as cancer and infections. Characterization methods to investigate the morphology and physicochemical properties of multifunctional NCs are key in their optimization and in the study of their in vitro and in vivo fate. Whereas a variety of methods has been developed to characterize “bulk” NCs in suspension, the scope of this review is to describe the different approaches for the NC characterization on an individual basis, for which fewer techniques are available. The accent is put on methods devoid of labelling, which could lead to artefacts. For each characterization method, the principles and approaches to analyze the data are presented in an accessible manner. Aspects related to sample preparation to avoid artefacts are indicated, and emphasis is put on examples of applications. NC characterization on an individual basis allows gaining invaluable information in terms of quality control, on: i) NC localization and fate in biological samples; ii) NC morphology and crystallinity; iii) distribution of the NC components (drugs, shells), and iv) quantification of NCs’ chemical composition. The individual characterization approaches are expected to gain increasing interest in the near future.     

对称向量拟均衡问题有效解的存在性

利用标量化方法建立对称向量拟均衡问题有效解的存在性定理。作为标量化方法的应用，利用这一方法得到向量变分不等式和拟向量变分不等式有效解的存在性定理。     

Strategy to mitigate single event upset in 14-nm CMOS bulk FinFET technology

Three-dimensional (3D) TCAD simulations demonstrate that reducing the distance between the well boundary and N-channel metal-oxide semiconductor (NMOS) transistor or P-channel metal-oxide semiconductor (PMOS) transistor can mitigate the cross section of single event upset (SEU) in 14-nm complementary metal-oxide semiconductor (CMOS) bulk FinFET technology. The competition of charge collection between well boundary and sensitive nodes, the enhanced restoring currents and the change of bipolar effect are responsible for the decrease of SEU cross section. Unlike dual-interlock cell (DICE) design, this approach is more effective under heavy ion irradiation of higher LET, in the presence of enough taps to ensure the rapid recovery of well potential. Besides, the feasibility of this method and its effectiveness with feature size scaling down are discussed.     

Mechanistic Investigation and Conductance Modulation of a Metal-Molecule-Metal Junction via Extra Acid Addition

One important prerequisite for the fabrication of molecular functional device strongly relies on the understanding the conducting behaviors of the metal-molecule-metal junction that can respond to an external stimulus. The model Lewis basic molecule 4,4′-(pyridine-3,5-diyl)dibenzonitrile (DBP), which can react with Lewis acid and protic acid, was synthesized. Then, the molecular conducting behavior of DBP, DBP-B(C₆F₅)₃, and DBP-TfOH (DBP-B(C₆F₅)₃, and DBP-TfOH were produced by Lewis acid and protonic acid treatment of DBP) was researched and compared. Given that their identical physical paths for DBP, DBP-B(C₆F₅)₃, and DBP-TfOH to sustain charge transport, our results indicate that modifying the molecular electronic structure, even not directly changing the conductive physical backbone, can tune the charge transporting ability by nearly one order of magnitude. Furthermore, the addition of another Lewis base triethylamine (of stronger alkaline than DBP), to Lewis acid-base pair reverts the electrical properties back to that of a single DBP junction, that is constructive to propose a useful but simple strategy for the design and construction of reversible and controllable molecular device based on pyridine derived molecule.     

配合参数对单晶炉驱动系统的影响分析

光伏产业的发展使得对硅材料的需求日益增加,同时硅单晶生产行业竞争也日趋激烈。作为生产硅单晶的重要装备,单晶炉的稳定性和可靠性关系到硅单晶生产效率的提升和成本的下降,因此其驱动系统的设计和优化成为装备制造的关键环节。本文以NVT-HG2000-V1型硅单晶生长炉的驱动系统为研究对象,用SolidWorks三维建模实现虚拟装配,采用ADAMS建立其动力学仿真模型,并对驱动系统的运动过程进行仿真模拟。采用控制变量法定量分析了铜套与升降轴的配合间隙及丝杠参数对驱动力和驱动力矩的影响规律,进而在提高硅单晶生长炉装备稳定性和可靠性方面给出合理的技术建议。结果表明,铜套与升降轴的配合间隙达到0.071 mm后能有效降低驱动系统运行所需驱动力矩,丝杠倾斜度、螺纹螺距与螺纹间摩擦系数的增大均会导致驱动系统运行所需力矩大幅增加。